KILLPGSection: Linux Programmer's Manual (2)
Index Return to Main Contents
NAMEkillpg - send signal to a process group
DESCRIPTIONkillpg() sends the signal sig to the process group pgrp. See signal(7) for a list of signals. If pgrp is 0, killpg() sends the signal to the sending process's process group.
(POSIX says: If pgrp is less than or equal to 1, the behaviour is undefined.)
For a process to have permission to send a signal it must either be privileged (under Linux: have the CAP_KILL capability), or the real or effective user ID of the sending process must equal the real or saved set-user-ID of the target process. In the case of SIGCONT it suffices when the sending and receiving processes belong to the same session.
RETURN VALUEOn success, zero is returned. On error, -1 is returned, and errno is set appropriately.
- Sig is not a valid signal number.
- The process does not have permission to send the signal to any of the target processes.
- No process can be found in the process group specified by pgrp.
- The process group was given as 0 but the sending process does not have a process group.
CONFORMING TOSVr4, 4.4BSD (The killpg() function call first appeared in 4BSD), POSIX.1-2001.
NOTESThere are various differences between the permission checking in BSD-type systems and System V-type systems. See the POSIX rationale for kill(2). A difference not mentioned by POSIX concerns the return value EPERM: BSD documents that no signal is sent and EPERM returned when the permission check failed for at least one target process, while POSIX documents EPERM only when the permission check failed for all target processes.
SEE ALSOgetpgrp(2), kill(2), signal(2), capabilities(7)