Linux Blog

READAHEAD

Section: Linux Programmer's Manual (2)
Updated: 2004-10-05
Index Return to Main Contents
 

NAME

readahead - perform file readahead into page cache  

SYNOPSIS

#include <fcntl.h>

ssize_t readahead(int fd, off64_t *offset, size_t count);
 

DESCRIPTION

readahead() populates the page cache with data from a file so that subsequent reads from that file will not block on disk I/O. The fd argument is a file descriptor identifying the file which is to be read. The offset argument specifies the starting point from which data is to be read and count specifies the number of bytes to be read. I/O is performed in whole pages, so that offset is effectively rounded down to a page boundary and bytes are read up to the next page boundary greater than or equal to (offset+count). readahead() does not read beyond the end of the file. readahead() blocks until the specified data has been read. The current file offset of the open file referred to by fd is left unchanged.  

RETURN VALUE

On success, readahead() returns 0; on failure, -1 is returned, with errno set to indicate the cause of the error.  

ERRORS

EBADF
fd is not a valid file descriptor or is not open for reading.
EINVAL
fd does not refer to a file type to which readahead() can be applied.
 

CONFORMING TO

The readahead() system call is Linux specific, and its use should be avoided in portable applications.  

NOTES

The readahead() system call appeared in Linux 2.4.13.  

SEE ALSO

fadvise(2), lseek(2), madvise(2), mmap(2), posix_fadvise(2), read(2)


 

Index

NAME
SYNOPSIS
DESCRIPTION
RETURN VALUE
ERRORS
CONFORMING TO
NOTES
SEE ALSO




Random Man Pages:
perlebcdic
setfsgid
nv
sane-config